Specifications

7.0 ASSEMBLY
9
7
.1 ASSEMBLY
& HARDWARE
REF # DESCRIPTION QTY
Z03 Wrench (M10)
Z02 Wrench (M8)
Z01 Screw Driver
Z53 Screw, Socket Head (M5x12L)
Z52 Screw, Socket Head (M8x30L)
Z50 Washer (30x2.0t)
1
1
1
8
8
4
2
Z51 Screw, Socket Head (M10x25L)
Z52
Z52
STEP 2
Z50
Z50
Z51
Z51
STEP 1
Connect the console cables from the console set to the motor control board
cables. Secure the console set with 2 screws (Z52) on each side.
• ATTENTION
After installation is completed, the treadmill will need to be calibrated by using the
AUTO-CHECK
function. If this is not done, the treadmill's speed and incline values may be incorrect and damage the
treadmill. Do not stand on the belt when performing the
AUTO-CHECK
function.
• ASSEMBLY INSTRUCTIONS
To ensure correct assembly of the treadmill, carefully read and follow these steps:
Please make sure that the power plug is not plugged into the wall outlet while completing the following
procedure.
Remove the motor cover. Pull out the console cable and route it through the Right
console mast. Place the right console mast and then the left console mast in the
console post support brackets. Secure the Right and Left mast with the 4 bolts
provided (Z50, Z51). Make sure these bolts are tight.