Owner`s manual

4.1 RECUMBENT CYCLE
4.2 UPRIGHT CYCLE
4.3 HYBRID CYCLE
CHAPTER 4: Serial Number Location
3.1 RECUMBENT SEAT HEIGHT
To adjust the seat height on the Recumbent Cycle, locate the yellow
lever under the right side of the seat before you mount the Cycle. Place
your right hand on the yellow adjustment handle under the right side
of the seat. Place feet on the ground while seated and slide forward
if needed. Place feet on pedals, gently lift lever under the right side
of the seat. Using legs slowly push and slide the seat up or down to
desired position. Release lever and allow to lock into place.
3.2 UPRIGHT SEAT HEIGHT
To adjust the seat height on the Upright Cycle, locate the yellow pull
pin before you mount the Cycle. To raise or lower the seat, pull the
yellow knob while holding the seat with the other hand and slide up
or down accordingly. Make sure you are not seated when you pull the
knob or pull the seat up.
3.3 HYBRID SEAT HEIGHT
To adjust the seat height on the Hybrid Cycle, pull the yellow lever
under the seat and lower the seat to the lowest position before getting
on the machine. With the seat in the lowest position, stand over the
seat and grab the yellow lever. Pull the lever and lift until the seat base
makes contact with your pelvic bone.
3
CHAPTER 3: Adjusting the seat
SERIAL #
PLACEMENT
SERIAL #
PLACEMENT
SERIAL #
PLACEMENT
06'_Cycle's_M.indd 7 7/18/06 1:04:57 PM