Specifications

•
Network Management and Monitoring on page 176
•
Software Installation and Upgrade on page 176
Hardware
•
CCG configuration change does not reprogram hardware automatically. PR896226
General Routing
•
"rnh_get_forwarding_nh: RNH type 1 unexpected" kernel error messages observed.
PR866282
•
Remote End connected to an interface of PTX 4x100GE PIC, might observe interface
flap with active MAC RF, even if the link switching is being done well within the interface
hold-down timer configured at Remote End. PR909635
•
This PR fixes the issue where output ifIndex being exported as 0. Unless there is a
critical business need, we do not plan to backport the fix to releases earlier than 14.1
PR964745
•
The PTX Series router is not supposed to generate pause frames even if it gets
congestion. The behavior is to drop aggressively if it ever runs out of queuing memory.
PR968803
•
When "request system halt" is executed on a PTX Series router, the Routing Engine is
halted, but the PTX Series router does not display Halt message on the CRAFT-Interface
confirming that the system has halted. PR971303
•
Traffic loss might be seen on flapping the CE-PE interface on the PTX platform.
Although on using 13.3R4.6 or higher release no traffic loss will be seen on flapping the
access facing interface. PR1026955
175Copyright © 2015, Juniper Networks, Inc.
Known Issues