Specifications

1. Disable graceful Routing Engine switchover (GRES) on the master Routing Engine
and save the configuration change to both Routing Engines.
2. Install the new Junos OS release on the backup Routing Engine while keeping the
currently running software version on the master Routing Engine.
3. After making sure that the new software version is running correctly on the backup
Routing Engine, switch over to the backup Routing Engine to activate the new software.
4. Install the new software on the original master Routing Engine that is now active as
the backup Routing Engine.
For the detailed procedure, see the Installation and Upgrade Guide.
Upgrading Juniper Network Routers Running Draft-Rosen Multicast VPN to Junos
OS Release 10.1
In releases prior to Junos OS Release 10.1, the draft-rosen multicast VPN feature
implements the unicast lo0.x address configured within that instance as the source
address used to establish PIM neighbors and create the multicast tunnel. In this mode,
the multicast VPN loopback address is used for reverse path forwarding (RPF) route
resolution to create the reverse path tree (RPT), or multicast tunnel. The multicast VPN
loopback address is also used as the source address in outgoing PIM control messages.
In Junos OS Release 10.1 and later, you can use the router’s main instance loopback
(lo0.0) address (rather than the multicast VPN loopback address) to establish the PIM
state for the multicast VPN. We strongly recommend that you perform the following
procedure when upgrading to Junos OS Release 10.1 if your draft-rosen multicast VPN
network includes both Juniper Network routers and other vendors’ routers functioning
as provider edge (PE) routers. Doing so preserves multicast VPN connectivity throughout
the upgrade process.
Because Junos OS Release 10.1 supports using the router’s main instance loopback (lo0.0)
address, it is no longer necessary for the multicast VPN loopback address to match the
main instance loopback adddress lo0.0 to maintain interoperability.
NOTE: You might want to maintain a multicast VPN instance lo0.x address
to use for protocol peering (such as IBGP sessions), or as a stable router
identifier, or to support the PIM bootstrap server function within the VPN
instance.
Complete the following steps when upgrading routers in your draft-rosen multicast VPN
network to Junos OS Release 10.1 if you want to configure the routers’s main instance
loopback address for draft-rosen multicast VPN:
1. Upgrade all M7i and M10i routers to Junos OS Release 10.1 before you configure the
loopback address for draft-rosen Multicast VPN.
NOTE: Do not configure the new feature until all the M7i and M10i routers
in the network have been upgraded to Junos OS Release 10.1.
Copyright © 2015, Juniper Networks, Inc.160
Release Notes: Junos OS Release 13.3R6 for the EX Series, M Series, MX Series, PTX Series, and T Series