User manual

MTX-HSPA-PH8-P+G UMTS-HSPA terminal modem http://www.matrix.es
MTX-HSPA-PH8-P+G User Manual V.1.0 Pag. 8
Preliminary. Subject to change without prior notice
Feature Implementation
SMS Point-to-point
MT and MO Cell broadcast
Text and PDU mode
Audio Audio speech codecs
GSM: AMR, EFR, FR, HR
3GPP: AMR
Speakerphone operation, echo cancellation, noise suppression, 9 ringing
tones, TTY support
GNSS Protocol NMEA
Modes
Standalone GNSS
Assisted GNSS
- Control plane - E911
- User plane - gpsOneXTRA™
General
Power saving modes
Power supply for active GNSS antenna supported
Software
AT commands
Hayes, 3GPP TS 27.007 and 27.005, and proprietary Cinterion
Wireless
Modules commands
MicrosoftTM compatibility RIL / NDIS / USB drivers for Windows MobileTM
SIM Application Toolkit SAT Release 99
Firmware update Firmware update from host application over USB or ASC0.
Interfaces
USB Supports a USB 2.0 Full Speed (12Mbit/s) device interface.
Serial Port RS232 9 wire modem interface
Wakeup Control Signal pin to wake up an inactive USB Host into an active state.
Status LED to indicate network connectivity status.
Audio 1 analog interface handset
UICC interface Supported chip cards: SIM / UICC 3V, 1.8V
Antenna 50 Ohms. External antenna can be connected via FME M antenna connector
Module interface Mini USB-B connector
Power on/off, Reset
Power on/off Switch-on by hardware pin TURN_ON
Switch-off by hardware pin TURN_OFF
Switch-off by AT command
Reset Orderly shutdown and reset by AT command
Emergency off Emergency off by hardware pin TURN_OFF