User manual

MTX-HSPA-PH8-P+G UMTS-HSPA terminal modem http://www.matrix.es
MTX-HSPA-PH8-P+G User Manual V.1.0 Pag. 6
Preliminary. Subject to change without prior notice
1.2 Highlights
General features:
• HDPA 14.4 Mbps
• Tri-Band UMTS/HSPA (WCDMA/FDD) 850/1900/2100 MHz
• Quad-Band GSM 850/900/1800/1900 MHz
• EDGE (E-GPRS) multi-slot class 10
• GPRS multi-slot class 10
• UMTS/HSDPA 3GPP release 5
• GSM 3GPP release 99
• Output power:
- Class 4 (2 W) for GSM900
- Class 3 (0.25 W) for UMTS/HSDPA
- Class E2 (0.5 W) for EDGE900
- Class E2 (0.4 W) for EDGE1800
- Class 1 (1 W) for GSM1800
• Control via AT commands (Hayes 3GPP TS 27.007 and 27.005)
• Power consumption:
- Power down 50 μA
- Average Supply Current < 970mA (HSDPA data transfer)
• Temperature range
- Normal Operation: -20°C to +65°C
- Restricted Operation: -30°C to +75°C
- Storage: -40°C to +85°C
• Dimensions. Excluding connectors: 78.1 x 66.8 x 37.2 mm
• Weight: < 190 g
• Supply voltage range: 6 ... 30 V
Specification for HSDPA data transmission:
• HSDPA: max. 3.6 Mbps (DL), max. 384 kbps (UL)
• UE CAT [1-6], 11, 12 supported
• Compressed mode according to 3GPP TS25.212
Specification for UMTS data transmission:
• UMTS: max. 384 kbps (DL), max. 384 kbps (UL)
Specification for EDGE data transmission:
• EDGE class 10: max. 236.8 kpbs (DL), max. 118 kbps (UL)
• Mobile station class B
• Modulation and coding scheme MCS 1-9
Specification for GPRS data transmission:
• GPRS class 10: max. 85.6 kbps (DL), max. 42.8 kbps (UL)
• Mobile station class B
• Full PBCCH support
• Coding schemes CS 1-4
Specification for CSD data transmission:
• GSM data rate 14.4 kpbs, V.110
• UMTS data rate 57.6 kpbs V.120
• RLP (Non-transparent mode)
Interfaces:
 FME M 50 Ohm GSM-UMTS antenna connector
 SMA F GPS antenna connector
 USB 2.0 full speed interface
 RS232 9-wire modem interface serial port
 Operating status LED bi-color
 SIM card interface 3 V, 1.8 V
 Plug-in power supply and on/off interfaces
 Handset audio interface
Specification for SMS:
• Point-to-point MO and MT
• SMS cell broadcast
• Text and PDU mode
Specification for voice:
 Audio speech codecs
 GSM: AMR, EFR, FR, HR
 3GPP: AMR
 DTMF supported
 6 audio modes: Approval, Router, Handset, Headset,
Speakerphone and Transparent mode
 TTY support selecting a dedicated audio mode
 Gains and volumes can be controlled by AT commands
 9 ringing melodies
 CEPT and ANSI supervisory tones supported
Special features:
• Improved power-saving modes
• NDIS/USB driver for Microsoft® Windows® XP
• RIL/NDIS/USB driver for devices based on Microsoft® Windows
Mobile™5.0 and its successor
• Firmware update via USB
GPS Features
 Protocol NMEA
 Modes GPS, assisted GPS (AGPS)
 Acquisition sensitivity: -143dBm

Tracking sensitivity -156dBm
 Power supply for active antenna
Ordering information: MTX-HSPA-PH8-P+G: 199.801.087 firmware 02.050