Technical data

OPC Routing Software SINAUT MICRO SC
SINAUT MD720-3
26 C79000-G8900-C210
Example:
8 Bytes starting at address 500 of the S7-200 with the stationname „S1“ are
addressed e.g. as:
TSC:[S1]DB1,B500,8
Notice
The signal quality as well as the data volume counters are not updated every time
because costs for higher data volume are generated. The information are updated
in periodic time intervals (about every hour). This interval is appropriate for
monitoring the station’s running behaviour. Updating these values by synchronous
reading commands from the OPC client is possible at any time.
Refresh_Values
After the start of the OPC clients it is necessary to set the bit „Refresh Values“ to 1.
Only then the SPS will tramit the actual values.
6.3 OPC access path
In case the OPC client allows to define an access path, the stationname can be
used as access path and the address as item ID.
Example:
Access path: MSC:[S1]
Item ID: DB1,INT100
Alternatively the complete address can be given as OPC item ID (with an empty
access path).
Example:
Access path: -
Item ID: MSC:[S1]DB1,INT100