Technical data

Configuration software for SINAUT ST7

1.9 Subscriber administration in the SINAUT configuration tool

Software

System Manual, 07/2009, C79000-G8976-C222-07

● Station: Name of the station assigned in the network configuration in

NetPro

● SINAUT connected: Specifies whether a SINAUT connection was configured for the

subscriber.

● SINAUT library: Name of the SINAUT software block library for CPU and TD7onTIM-

compliant TIM modules.

The setting of the subscriber-related properties is made in the

Properties of subscriber

dialog

that is opened when you double-click on one of the subscribers in the list.

Marking for selective system data generation

In the subscriber administration, it is possible to select any CPU subscriber for later selective

generation of the software blocks. To select a subscriber, click in the check box in front of

the subscriber number (a check mark is set). The number of selected CPU modules is

displayed in the text box

Selected CPUs:

above the list. You can remove the check mark

again by clicking with the mouse.

Changing the subscriber number

To change the subscriber number, click on the required subscriber. By clicking again on the

subscriber number, by typing

Alt+Return

, by pressing function key F2 or by selecting the

Edit / Change Subscriber

, the

Subscriber number

field becomes editable. The user

can then enter any unassigned subscriber number as required.

Dialogs below the subscriber list

Any dialogs displayed below the subscriber list are used for configuring the TD7 software for

the TIM (TD7onTIM) that can only be configured for TD7onTIM-compliant TIM modules.

These dialogs are not available for other subscribers. The TD7onTIM is configured and the

parameter settings made following this in the subscriber parameter assignment.

Generating a redundant ST7cc/sc control center

If two SIMATIC PC stations were configured for a redundant SINAUT ST7cc/sc control

center, the assignment of the two redundant partners is made at this point. To do this, select

the entry "Redundant ST7cc/ST7sc server" in the directory tree and select "Add redundant

ST7cc/ST7sc..." from the shortcut menu (right mouse button).

You can delete a redundancy grouping again by selecting the entry of the redundancy

grouping in the directory tree and then selecting the "Delete redundant object" shortcut menu

command. This deletes only the data of the grouping but not the underlying subscribers.

For detailed information on configuring a single or redundant ST7cc/ST7sc control center,

refer to the SINAUT ST7cc or ST7sc documentation.