Technical data

Configuration software for SINAUT ST7
1.9 Subscriber administration in the SINAUT configuration tool
Software
System Manual, 07/2009, C79000-G8976-C222-07
87
1.9 Subscriber administration in the SINAUT configuration tool
Once the SINAUT ST7 connections have been configured, all the requirements are met so
that you can
● create,
● display,
● process and
● pack the subscriber data for the ST 7 communication subscribers so that it can be
understood by the hardware components; in other words, in data blocks (DBs) or system
data blocks (SDBs).
Processing is always necessary when data needs to be acquired that is connection-related;
in other words cannot be assigned to a particular subscriber.
Processing of subscriber data is also necessary when SINAUT data is stored for non-
SINAUT objects, for example the DB configuration for the CPU modules and SMS
messages.
How to set parameters for this data in the subscriber administration of the SINAUT
configuration tool is described below.
After starting subscriber administration, first the previously known data of the subscribers is
loaded from the data management and then updated. The following data is updated:
● Subscriber information: Which subscribers exist?
● Networking information: Who communicates with whom over which connections?
● DB configuration information: Which data blocks are generated for a CPU?
The subscriber list always shows the latest situation in the SINAUT subscriber world.