Technical data

Configuration software for SINAUT ST7
1.8 Configuring connections in the SINAUT Configuration Tool
Software
System Manual, 07/2009, C79000-G8976-C222-07
85
Connections dialog. The connections contained here are then not included in the list of
possible connections .
The
Invalid Connections dialog is displayed using the SINAUT / Show Invalid Connections
menu or the
Show Invalid Connections button in the toolbar.
Figure 1-43 Invalid Connections dialog
If you expand a connection structure in the list of
invalid connections by double-clicking on it
and if you then select a single connection, the reason for the invalidity and a note on how to
remedy the situation are displayed in the lower part of the dialog. The note might, for
example, inform you that the connection should be configured in the reverse direction.
Within SINAUT ST7, permitted connections must adhere to the following rules:
● A connection must not run through an inconsistent network. Examples are described
along with the plausibility check in the network configuration.
● A connection must not run through a WAN sub-connection on which two MD3 modems
communication each other using 1200 bauds / half duplex / AT mode.
● A connection should not run from a station or node station TIM to a master TIM. The
reverse direction is preferable.