Technical data

Configuration software for SINAUT ST7
1.8 Configuring connections in the SINAUT Configuration Tool
Software
System Manual, 07/2009, C79000-G8976-C222-07
81
1.8 Configuring connections in the SINAUT Configuration Tool
1.8.1 Configuring SINAUT connections
The SINAUT ST7 connections
In SINAUT ST7 installations, connections are always configured between the following
subscribers:
● From CPU to CPU
● From CPU to a SINAUT ST7cc/ST7sc control center
Figure 1-41 Example of a SINAUT ST7 connection from the master station to station 1
The connection shown in dark red from the master station to station 1 is not visualized in this
form in the network configuration with NetPro.
This is taken into account in the connection configuration that allows the user
● to configure connections without knowing the exact connection path and
● to view the exact connection path over a list of used network nodes. The degree of detail
of the connection information can be set by users themselves.