Manualshelf

Technical data

ManualsBrandsMatrix ManualsKitchen AppliancesMD720
71727374757677787980
Configuration software for SINAUT ST7
1.6 Configuring networks and network nodes in STEP 7 / NetPro
Software
74 System Manual, 07/2009, C79000-G8976-C222-07
Dialing Param.
tab
The
Dialing Param.
tab appears only with dial-up network nodes and includes all parameters
specific to call-numbers.
Figure 1-38
Properties - SINAUT Dedicated Line TIM
dialog,
Dialing Param.
tab
The parameters here are:
●
Configured modem
:
The modem specified in the hardware configuration is displayed.
●
Dialing mode
:
Specifies how the modem is controlled. Note that only the AT mode can be used on the
internal interface of the TIM. A choice between AT mode and V.25bis is possible only for
the external WAN interface.
Range of values: AT mode, V.25bis
Default: AT mode
●
Dialing format
:
The data format of the dial-up phase depends on the type of modem. The following
settings are possible:
8 data bits, no parity, 1 stop bit
8 data bits, odd parity, 1 stop bit
8 data bits, even parity, 1 stop bit
8 data bits, no parity, 2 stop bits
8 data bits, odd parity, 2 stop bits
8 data bits, even parity, 2 stop bits
7 data bits, no parity, 1 stop bit
7 data bits, odd parity, 1 stop bit