Technical data

Configuration software for SINAUT ST7
1.6 Configuring networks and network nodes in STEP 7 / NetPro
Software
62 System Manual, 07/2009, C79000-G8976-C222-07
● The transmission rate :
Just like the highest MPI address, this cannot be modified here but only in the parameter
assignment of the MPI network.
● The
Subnet :
This lists all the networks of this type in the project. If the subscriber is not connected, the
row
----not networked---- is shown as selected in the Subnet list.
– If the current subscriber is connected, the row of the relevant network is shown as
selected. You can set parameters for the current network with the
Properties button.
– If no connection exists, a network connection can be set up using the
New button.
– An existing connection can be deleted with the
Delete button.
1.6.6 Setting parameters for Ethernet nodes
This type of interface is available among the SINAUT subscribers only for the Ethernet TIMs.
General tab
Figure 1-30 Properties - Ethernet interface dialog, General tab
The
General tab informs you about general parameters of the Ethernet interface.