Technical data

Configuration software for SINAUT ST7
1.6 Configuring networks and network nodes in STEP 7 / NetPro
Software
60 System Manual, 07/2009, C79000-G8976-C222-07
Repeat this procedure if you want to use more than one time slot per minute.
In the multi-master polling with time slots mode, this must be done for each of the polling
masters with different time slots.
You can delete a selected time slot again with the
remove assignment button.
Note
Master TIM
The time slot method can now also be configured with the "SINAUT ST7 configuration
software for the PG/PC" as of Version V4.2 for a master TIM without DCF7 receiver when a
TIM 4R-IE with an Ethernet connection to an ST7cc-/ST7sc PC is used as the master TIM.
1.6.5 Setting parameters for MPI network nodes
General tab
The General tab informs you about general parameters of the MPI interface.
Figure 1-28 Properties - MPI interface dialog, General tab
The following parameters are available:
● Name:
The
Name box displays the name of the module in SIMATIC stations. You can only