Technical data

Configuration software for SINAUT ST7
1.6 Configuring networks and network nodes in STEP 7 / NetPro
Software
52 System Manual, 07/2009, C79000-G8976-C222-07
● The Date of the last modification is displayed.
● In the
Comment input box, you can enter comments of up to 254 characters.
1.6.4 Setting parameters for SINAUT networks
You set parameters for SINAUT networks (WANs) in the Properties - SINAUT Dedicated
Line
or in the Properties - SINAUT Dial-up Network dialog. The parameters to be set in the
following tabs always apply to the entire network and are identical for all attached network
nodes or communication partners:
●
General
tab with general information and for modifying the module name or adding comments
●
Network settings
for setting the communication parameters of the current SINAUT network
●
Time Service
tab for setting parameters for time synchronization on the SINAUT network
●
Node List
tab with the list of all subscribers on the current SINAUT network
●
Time Slots tab (only for the corresponding polling mode)
to specify the time slots for polling
General tab
Figure 1-23 Properties - SINAUT Dedicated Line dialog, General tab