Technical data

Configuration software for SINAUT ST7
1.6 Configuring networks and network nodes in STEP 7 / NetPro
Software
System Manual, 07/2009, C79000-G8976-C222-07
51
1.6.3 Setting parameters for Industrial Ethernet the
General tab
You set the parameters for Industrial Ethernet in the Properties - Industrial Ethernet dialog.
Figure 1-22 Properties - Industrial Ethernet dialog, General tab
The following parameters are available in this tab:
●
Name :
The default entry in the
Name input box is the default name of the network. You can
change this to suit your purposes. A new, modified name appears in the SIMATIC
Manager and in the network configuration.
●
S7 subnet ID :
The subnet ID is made up of two numbers separated by a dash:
– The number for the project
– The number for the subnet
If you want to go online with a PG without a consistent project, you must know the subnet
ID. The subnet ID is also printed out when you print the network configuration.
● The
Project path is displayed.
● The
Storage location of the project is displayed.
● In the
Author input box, you can enter the person who created the configuration.
● The
Date created is displayed.