Manualshelf

Technical data

ManualsBrandsMatrix ManualsKitchen AppliancesMD720
41424344454647484950
Configuration software for SINAUT ST7
1.6 Configuring networks and network nodes in STEP 7 / NetPro
Software
50 System Manual, 07/2009, C79000-G8976-C222-07
Network Settings
tab
Figure 1-21
Properties - MPI
dialog,
Network Settings
tab
The following parameters are available:
● The
Highest MPI address
is displayed.
This is used to optimize the MPI network. It is advisable to retain the highest MPI address
proposed by STEP 7.
● The
Change
option:
By activating the option, you can modify the highest MPI address.
●
Transmission rate
:
The setting of the transmission rate of the MPI network depends on the properties of the
MPI subscribers used and must not be higher than the slowest subscriber. The default
can normally be accepted.