Technical data

Configuration software for SINAUT ST7
1.6 Configuring networks and network nodes in STEP 7 / NetPro
Software
System Manual, 07/2009, C79000-G8976-C222-07
49
General tab
Figure 1-20 Properties - MPI dialog, General tab
The following parameters are available in this tab:
●
Name :
The default entry in the
Name input box is the default name of the network. You can
change this to suit your purposes. A new, modified name appears in the SIMATIC
Manager and in the network configuration.
●
S7 subnet ID :
The subnet ID is made up of two numbers separated by a dash:
– The number for the project
– The number for the subnet
If you want to go online with a PG without a consistent project, you must know the subnet
ID. The subnet ID is also printed out when you print the network configuration.
● The
Project path is displayed.
● The
Storage location of the project is displayed.
● In the
Author input box, you can enter the person who created the configuration.
● The
Date created is displayed.
● The
Date of the last modification is displayed.
● In the
Comment input box, you can enter comments of up to 254 characters.