Technical data

Configuration software for SINAUT ST7
1.6 Configuring networks and network nodes in STEP 7 / NetPro
Software
48 System Manual, 07/2009, C79000-G8976-C222-07
● The TIM 3V-IE Advanced of the node station was connected to Ethernet 1 and dedicated
line 1.
● The TIM 3V-IE in station 21 was connected to dedicated line 1.
● The TIM 3V-IE in station 31 (GPRS station) was configured for the MSC protocol and
connected to Ethernet 2.
Special feature: With this configuration, the WAN node to the right of the TIM is displayed
green and is connected to the Ethernet network.
● The TIM 3V-IE Advanced in station 41 (GSM station) was connected to dial-up network 1.
The blue WAN connection of the master TIM and the connection of the node station to
dedicated line 1 are shown in dark blue and indicate a connection in which the connected
interface for the relevant subnet was configured as a master station. This is explained in the
description of the network node parameter assignment.
Note
After changing connections, even if these are re-established again later, the SINAUT
configuration tool with the
connection configuration and the subscriber administration must be
called.
Printing network information
The project can be printed and documented as a graphic or as text using the Network / Print
menu.
1.6.2 Setting parameters for MPI networks
To set parameters for MPI networks, you open the Properties - MPI dialog by double-clicking
on the MPI network, or using the
Object Properties... context menu.