Technical data

SINAUT PG Routing
4.3 Application of PG routing
Software
System Manual, 07/2009, C79000-G8976-C222-07
445
10. Save your project in NetPro .
11. Connect your PG/PC to the MPI bus to which you assigned your PG/PC in
NetPro over a
PG cable.
Figure 4-11 Project view in NetPro with assigned PG/PC
Note
As long as you leave your PG/PC connected to the point in the network as you assigned it in
NetPro , you do not need to cancel the assignment. Not even if you want to turn off the
PG/PC. Each time you turn on the PG/PC and open the project, you can use PG routing
again immediately. You do not need to make settings or assignments again.
If, on the other hand, your PG/PC is not always at the same location or if you change to
different projects on your PG/PC, we strongly recommend that you always cancel the
assignment before your PG/PC is turned off or before you change to a different project. This
ensures that the PG/PC can be assigned again when used at a different location or in a
different project.