Technical data

SINAUT PG Routing
4.3 Application of PG routing
Software
System Manual, 07/2009, C79000-G8976-C222-07
443
5. Confirm the warning dialog with Yes . The Properties dialog opens.
6. In the
MPI tab of the Properties dialog, select the option 100 s in the Timeout list.
7. Close the
Properties and Set PG/PC Interface dialogs with the OK button and then close
the
Control Panel window.
Figure 4-9 Properties dialog of the interface in the Control Panel
This completes the adaptation of the PG/PC interface.
4.3.2 PG/PC assignment in the SINAUT network
Before you can use PG routing with a PG/PC over SINAUT networks, this must be
configured and assigned within a SINAUT project.
Assigning the PG/PC
The PG/PC is assigned in the network using the SIMATIC network configuration tool NetPro.
1. Open the project in which you want to use PG routing in the SIMATIC STEP 7
NetPro
network configuration tool.
2. Open the NetPro catalog if it is not already open.
3. Drag a PG/PC to the network window from the NetPro catalog directory
Stations and
place it at a suitable position.
4. Right-click on the PG/PC you have just installed. A context menu opens.
5. In the context menu, click on the
Assign PG/PC option. The Properties dialog opens.