Technical data

SINAUT PG Routing
4.2 System requirements for PG routing
Software
System Manual, 07/2009, C79000-G8976-C222-07
435
● Download function
The
download of an entire station (CPU 300 plus TIM) leads to a connection abort. Since
the TIM system data are downloaded first followed by a restart on the TIM, the second
step of the CPU data download is interrupted.
It is possible to repeat the CPU download. We, nevertheless, recommend that you
download the block folder of the CPU and the TIM module separately.
●
Upload to PG function
The
upload to PG function is available only for subscribers connected to the local MPI
bus. This restriction applies to SIMATIC PG routing and therefore also to SINAUT PG
routing.
Restrictions for PG routing with SINAUT ST1 components
For more information on SINAUT ST1, refer to release 05/2007 of the manual.
4.2 System requirements for PG routing
Introduction
To use the PG routing function in the SINAUT telecontrol network with SINAUT ST7, the
following requirements must be met or preparations made.
● STEP 7 with at least Version 5.1 and service pack 3 is required on the PG/PC.
● The SINAUT software package version V3.0 or higher must be installed on your PG/PC.
● The RMOS operating system of the TIM modules of the type TIM 3 and TIM 4 in your
telecontrol network should be at least version 2.14. TIM modules of version 2.04 can be
used with certain restrictions.
● The TIM firmware for the TIM 3 and TIM 4 must have a certain minimum version.
With dedicated lines, firmware version V 3.14 is required.
In dial-up networks, a minimum firmware version of V 3.46 is required.
● For SINAUT dedicated line or dial-up networks, a maximum message length of 240 must
be set.
● On slow connections with only 1200 bauds transmission speed, the Retry factor must be
set higher than 0.
● For PG routing, new SDBs must be transferred to the TIM modules. These are compiled
with the SINAUT software package as of V3.0.
Note
PG routing is released for the Ethernet TIMs regardless of the firmware version.