Manualshelf

Technical data

ManualsBrandsMatrix ManualsKitchen AppliancesMD720
41424344454647484950
Configuration software for SINAUT ST7
1.5 Setting TIM module parameters
Software
System Manual, 07/2009, C79000-G8976-C222-07
43
internal interface. The type of a modem on the external interface must be configured over the
list box.
The modem type is checked during the plausibility checks to establish whether or not it is
compatible with the current network parameters. In addition to this, a default AT string for a
SINAUT dial-up modem or GSM module is derived from the mode type and the network
parameters
Baud rate
,
Message format
and
Connection type
(duplex, half duplex).
1.5.8 "Options" tab
Options
tab
In the
Options
tab, you can set parameters for the message memory.
Figure 1-16
Properties - TIM
dialog,
Options
tab
The following parameters can be set in the
Global message memory
area:
●
Size
:
This is the size of the memory in which the messages to be transmitted are stored for all
configured WAN drivers. If the value 0 is entered here, the entire free memory following
startup is used.