Technical data

Configuration software for SINAUT ST7
1.5 Setting TIM module parameters
Software
42 System Manual, 07/2009, C79000-G8976-C222-07
Figure 1-15 Properties - TIM dialog, WAN Access tab
For each of the two WAN accesses, you can make the following entries depending on the
display in the
internal/external WAN interface :
● Interface list box disabled with
Dedicated line , spontaneous network or dial-up network :
There is already a network node for this interface. Using the
Properties... button, you can
branch to the
Properties dialog of the network node to make parameter settings. With the
Delete... button, you can remove the network node.
The
Properties dialog of the interface is written when you set parameters for the network
node.
● Interface list box selectable when
dedicated line , spontaneous network or dial-up network
is displayed:
There is not yet a network node for this interface. To create a network node, you must
select the corresponding interface type in the
Internal/external WAN interface list box.
With the
New... button, you create a network node of the type displayed in the interface
list box.
● Interface list box disabled with the display
Not available :
This interface cannot be operated by the current TIM module, no further parameter
assignment possible.
The type of connector modem is displayed for each interface
Modem type If a modem exists
on the TIM module or can be connected externally. This type cannot be changed for the