Technical data

SINAUT Diagnostics and Service tool
3.6 Messages in the diagnostic buffer of the TIM
Software
System Manual, 07/2009, C79000-G8976-C222-07
413
Event ID
(hex)
Detailed
event
(hex)
Meaning
F360 0084 RAM drive was created.
F560 0085 Error creating RAM drive.
F560 0086 Error in memory analysis in HEAP.
F560 0087 Error installing the clock driver. No message received at end of installation.
F360 0088 Message of the message and HEAP memory initialized on the TIM.
F360 0089 Routing SDB could not be found.
F560 008A Routing SDB could not be opened.
F560 008B Routing SDB starts with incorrect subnet block ID.
F560 008C No memory available for routing function.
F560 008D Incorrect block ID detected in routing SDB.
F560 008E Error sending a job to the LAN task.
F560 008F Installation of the routing function was aborted.
F560 0090 ST7 installation started.
F360 0091 Wrong TIM firmware loaded.
F560 0100 Module startup: Installation error
LAN messages
F560 0101 Installation of the AMPLUS-L emulation aborted.
F560 0103 LAN communication: Error sending a message.
F560 0104 LAN communication: Error receiving a message or ID unknown.
F360 0105 LAN communication: Unknown job.
F360 0106 LAN communication: Connection could not be entered in routing table.
F360 0107 LAN communication: Connection could not be deleted in routing table.
F560 0108 LAN communication: Error in a connection SDB.
F360 0109 LAN communication: No resources available for connection.
F560 010A LAN communication: PBC connection could not be established. Reference number unknown.
F560 010B LAN communication: PBC connection could not be established. Reference number unknown.
F360 Entering state: LAN communication: Connection down.
F260
010C
Exiting state: LAN communication: Connection OK.
F560 Entering state: LAN communication: Threat of send queue overflow for a connection.
F460
010D
Exiting state: LAN communication: Threatening send queue overflow for a connection
eliminated.
F560 Entering state: LAN communication: Send queue overflow for a connection.
F460
010E
Exiting state: LAN communication: Send queue overflow for a connection eliminated.
F560 Entering state: Disruption of MPI/party line interface (SPC/2) detected.
F460
010F
Exiting state: Disruption of MPI/party line interface (SPC/2) eliminated.
F560 0110 LAN communication: Error reading the LAN SDB.
F560 0111 LAN communication: Error occurred during PBC send.
F560 0112 LAN communication: Error in SDB0 – bad MPI parameter.
F560 0113 LAN communication: A negative acknowledgment was sent.
F560 0114 No Ethernet SDB.
F560 0115 Ethernet SDB could not be opened.