Technical data

SINAUT Diagnostics and Service tool
3.3 SINAUT diagnostics
Software
System Manual, 07/2009, C79000-G8976-C222-07
391
Send On Command:
DBNo | memLoc | byteAdr | bitAdr|
0 |UNKNOWN| 0 | 0 |
Alarm Mask: 0
Send Buffer Principle Mask: 0
Disable Mask: 0
Input Data:
dataType | repeatF | dbNo | memLoc | byteAdr |
bitAdr|
BYTE | 1 | 0 | M | 11 | 0 |
----------------------------------------------------
----------------------
Ethernet data SDB
The Ethernet data SDB contains information on the IP address of the selected TIM module,
the subnet mask and any configured router. If, as in the case here, the address of the router
is the same as the IP address of the TIM, no router is set. The IP addresses are set in
network configuration.
Table 3- 14 Example of the information of an Ethernet data SDB (type 3100)
IP address : 140. 80. 0. 3
subnet mask : 255. 255. 0. 0
default router : 140. 80. 0. 3
Routing data SDB
The routing data SDB contains information on the individual subnets of a project. This is
illustrated below based on an example.
Table 3- 15 Example of the information of a routing data SDB (type 3002)
Subnet type ID, address
local subnet - local subnet ID : 47 11 00 00 00 0c
- local device ID : 03
local subnet - local subnet ID : 47 11 00 00 00 14
- local device ID : 02
remote subnet - remote subnet ID : 00 8a 00 00 00 01
- next station addr : 01
- local device ID : 03
etc.
Connection data (PBC) SDB
The connection data (PBC) SDB contains information on the PBC connections of a TIM
module. This is illustrated below based on an example.
Table 3- 16 Example of the information of a connection data (PBC) SDB (type 700)
STEP 7 connection - Connection setup: fixed configured, static