Technical data

SINAUT TD7 software package for the CPU
2.6 Blocks for optional expansion
Software
System Manual, 07/2009, C79000-G8976-C222-07
307
Bit .9 Status of the WAN connection resources:
0 0 = Sufficient resources on partner *)
1 1 = Insufficient resources on partner
Bit .10 Time status:
0 0 = Date/time not available / not OK on partner
1 1 = Date/time OK on partner
Bit .11 Time synchronization:
0 0 = The partner CPU received a plausible time during the last
synchronization or no synchronization time has been received
since startup.
1 1 = The partner CPU has received an implausible synchronization
time; the last valid time will continue to be used.
Note
Bit 11 cannot be displayed in conjunction with TimeTask version ≤ 1.6.
Note
The following parameters, GeneralRequest, PermanentCall_On and PermanentCall_Off are
in/out parameters (declaration IN_OUT). It is difficult to specify local bit memory with this
parameter type and this should not be used.
Name: GeneralRequest
Declaration: IN_OUT
Data type BOOL
Explanation Input for triggering a general request to the subscriber specified with
PartnerNo.
Range of
values:
Input
Bit memory
Data bit
I 0.0 ... I n.7
M 0.0 ... M n.7
DBm.DBX 0.0 ... n.7
A general request to the subscriber is triggered with a 1 signal at this input if
no request is active for this subscriber at this time. The input is then
automatically reset by the FC. If an input of a digital input is specified (I 0.0
... I n.7), the user is responsible for resetting the signal at the input. This
must be done before ending the currently running general request otherwise
another general request is triggered immediately.