Technical data

SINAUT TD7 software package for the CPU
2.6 Blocks for optional expansion
Software
System Manual, 07/2009, C79000-G8976-C222-07
305
Explanation of the parameters
Name: PartnerNo
Declaration: INPUT
Data type INT
Explanation SINAUT subscriber number of the subscriber to be monitored and controlled.
Range of
values:
1 ... 32000 [ms]
If the set PartnerNo is not found in the administration (in DB-BasicData), an
entry to this effect is made in the diagnostic buffer only during startup (event
ID B101). The CPU does not change to STOP. The status of a correctly
configured subscriber is indicated in the PartnerStatus output word and the
control inputs are processed. Unknown subscribers are not processed until
the parameter assignment error has been corrected. The PartnerStatus
output word remains set to 0 during this time.
Name: MaxConnectTime
Declaration: INPUT
Data type INT
Explanation Maximum connection duration for a permanent connection.
Range of
values:
0 (= no limit) or 1 ... 480 [minutes]
If the time specified here is greater than 0, it is activated at the start of a
permanent connection (see PermanentCall_On parameter). If the time
elapses before the permanent connection is reset, it is automatically
disconnected. The time is retriggered as long as the signal 1 is present at
the PermanentCall_On input.
The time specified here applies to a permanent connection in a dial-up
network as well as to a permanent connection (continuous polling) on a
dedicated line.
Name: PartnerStatus
Declaration: OUTPUT
Data type WORD
Explanation Output word to indicate the status of the subscriber to be monitored.
Range of
values:
Output words
Memory words
Data bit words
QW0 ... QWn
PQW0 ... PQWn
MW0 ... MWn
LW0 ... LWn
DBm.DBW0 ... n
If you do not require the parameter, simply leave it open.
The meaning of the status bits in the PartnerStatus output word: