Technical data

Configuration software for SINAUT ST7
1.5 Setting TIM module parameters
Software
28 System Manual, 07/2009, C79000-G8976-C222-07
and entering the start address in the input box manually. Since the addresses are always set
consistently by the system and are not generally used, it is not normally necessary to make a
change.
1.5.4 "Special" tab
Special tab
The Special tab shows the SINAUT subscriber number of the TIM module and you can set
the size and configuration of the diagnostic buffer.
Figure 1-10 Properties - TIM dialog, Special tab
This tab contains the following parameter assignment options:
●
SINAUT subscriber number box:
The project-wide unique SINAUT subscriber number is displayed here. For more data of
information, refer to the configuration of the
subscriber administration in the SINAUT
configuration tool.
●
SINAUT ST1 master number box:
In ST1 dial-up networks, the SINAUT ST1 master number must be specified for the TIM
modules. For more information on SINAUT ST1, refer to release 05/2007 of the manual.