Technical data

Configuration software for SINAUT ST7
1.5 Setting TIM module parameters
Software
System Manual, 07/2009, C79000-G8976-C222-07
27
● The Comment: input box allows you to enter comments, for example on the purpose of
the module.
The SINAUT subscriber number of the TIM module that can be generated as a comment
in the
Subscriber Administration of the SINAUT configuration software is then displayed
in this comment box.
1.5.3 "Addresses" tab
Addresses tab
Figure 1-9 Properties - TIM dialog, Addresses tab
The Addresses tab provides information on the address areas occupied by the TIM module
in the I/O from the perspective of the CPU.
These addresses are only relevant to you when the SINAUT program is configured on the
TIM (TD7onTIM, possible with Ethernet TIMs) and when the CPU is supplied with the date
and time by the TIM. In this case, the TIM supplies the time data to the inputs specified here.
This is described in detail elsewhere (refer to the section: Synchronization of the CPU time
with TD7onTIM)
The start address and length of the address ranges are assigned by the system. As an
alternative, you can change the inputs and outputs by disabling the system selection option