Technical data

SINAUT TD7 software package for the CPU
2.5 Data point typicals
Software
262 System Manual, 07/2009, C79000-G8976-C222-07
Name: NewData
Refer to
Parameters you require often (Page 223).
Explanation
of the
typical-
specific
outputs
Whenever the FB has received new data and has output it to the outputs
ReturnedSetpoint or LocalOperation, the NewData output is set to TRUE for
one OB1 cycle.
Name: SendSoftSetpoint
Declaration: IN_OUT
Data type BOOL
Default: FALSE
Explanation Trigger input for resending the last (software) setpoint.
Range of
values:
Bit memory
Data bit
No parameter specified:
Default value FALSE is valid.
M 0.0 ... M n.7
DBm.DBX 0.0 ... n.7
See also SetpointInput parameter.
If you do not require the parameter, simply leave it open.
Note
This is an in/out parameter (declaration IN_OUT). It is difficult to specify local bit memory
with this parameter type and this should not be used.
2.5.11 ST7 setpoint typical FB Set01W_R
Function
Receive or enter 1 setpoint locally (16 bits) and send the current, locally valid setpoint.
Explanation of the parameters
Names: PartnerNo
PartnerObjectNo
Enabled
ImageMemory
Conditional
Unconditional
Permanent