Technical data

Configuration software for SINAUT ST7
1.5 Setting TIM module parameters
Software
26 System Manual, 07/2009, C79000-G8976-C222-07
1.5.2 "General" tab
General tab
The General tab informs you about the general properties of a TIM module.
Figure 1-8 Properties - TIM dialog, General tab
This tab contains the following output boxes and parameter assignment options:
●
Short Designation: output area This displays the module type and a brief outline of the
hardware configuration.
● The
Order No. output box displays the order number of the module.
● The
Name: input box allows you to change the name of the module.
● As default, the
Interface area shows the address and the networking status of the MPI
interface. With the
Properties button, you can open a dialog for setting parameters of the
MPI node of the module. This is described in detail in the section on network node
parameter assignment.
Modules of the type series TIM 3 are also assigned an MPI address as default, even if
this does not physically exist. If you click the
Properties button, the parameters of the MPI
interface are not available for these modules in the next dialog.