Technical data

Configuration software for SINAUT ST7
1.5 Setting TIM module parameters
Software
System Manual, 07/2009, C79000-G8976-C222-07
25
● Time Service tab
for assigning parameters for time synchronization of a TIM module on the MPI bus or an
Ethernet TIM (TIM 3V-IE variants, TIM 4R-IE) on Ethernet
●
Interfaces tab
for configuring the Ethernet and WAN interface(s)
This tab exists only with Ethernet TIMs
●
WAN Access tab
for creating WAN interfaces of the TIM modules of type TIM 3/TIM 4
●
Options tab
with options for assigning parameters for the message memory and the message
indicating a failed local subscriber to substations over a dial-up network
Note
Communication-specific parameters are entered in the
Properties dialogs for network and
network node parameter assignment. These are explained in the relevant sections.