Technical data

SINAUT TD7 software package for the CPU
2.5 Data point typicals
Software
System Manual, 07/2009, C79000-G8976-C222-07
247
TimeStamp
Refer to
Parameters you require often (Page 223).
Name: GeneralTriggerCommand
Declaration: INPUT
Data type BOOL
Default: FALSE
Explanation General restore command:
Range of
values:
TRUE or FALSE
No parameter specified: Default value FALSE is valid.
Here, you specify whether or not a counted value transmission should be
triggered by a general restore command (the general restore command
belongs to the organizational SINAUT system commands).
If an explicit destination subscriber number (PartnerNo > 0) is assigned in
the typical, the general restore command is evaluated in the corresponding
subscriber object in the central administration. If the destination subscriber
number is missing (PartnerNo = 0, send ’to all’), the central system memory
bit ’General restore command’ is taken into account.
When the general restore command is detected, the currently accumulated
counted value is transmitted regardless of other criteria that affect message
transmission. The restore identifier US is inverted in this counted value.
Parameters GeneralTriggerCommand and TriggerInput can be used
together. Transmission is then triggered by a signal edge change from 0 to 1
at the TriggerInput as well as when a general restore command is received.
If no parameter is specified, the default is FALSE; in other words, there is no
restore using the general restore command.
Name: TriggerInput
Declaration: INPUT
Data type BOOL
Default: FALSE
Explanation Trigger input
TRUE or FALSE
No parameter specified: Default value FALSE is valid
Range of
values:
Input
Bit memory
Data bit
I 0.0 ... I n.7
M 0.0 ... M n.7
L 0.0 ... L n.7
DBm.DBX 0.0 ... n.7
If required, this parameter can be used to specify an input over which the
user can trigger (signal edge change from 0 to 1) a transmission at any time
regardless of other criteria that affect message transmission. The currently
accumulated counted value is transmitted. The restore identifier US is
inverted in this counted value.