Technical data

SINAUT TD7 software package for the CPU
2.5 Data point typicals
Software
226 System Manual, 07/2009, C79000-G8976-C222-07
• Sending process typicals
(Cmd01B_S, Set01W_S, Par12D_S)
The parameter setting PartnerNo = 0 is not permitted!
If the parameter setting is incorrect (< 1 or > 32000), an error message to
this effect is entered in the diagnostic buffer (event ID B100). If the value
range is correct, but the PartnerNo was not found in the administration (in
DB-BasicData), an entry is also made in the diagnostic buffer (event ID
B101). The CPU does not change to STOP. The FB is then no longer
processed, however, until the parameter assignment error has been
corrected.
• Receiving process typicals
(Bin04B_R, Ana04W_R, Cnt01D_R/Cnt04D_R, Dat12D_R)
The parameter setting PartnerNo = 0 is not permitted!
If the parameter setting is incorrect (< 1 or > 32000), an error message to
this effect is entered in the diagnostic buffer (event ID B100). If the value
range is correct, but the PartnerNo was not found in the administration (in
DB-BasicData), an entry is also made in the diagnostic buffer (event ID
B101). The CPU does not change to STOP. The FB is then no longer
processed, however, until the parameter assignment error has been
corrected.
If the PLC receives a message for the object set here, the system checks
whether the source subscriber number in the message is identical to the
PartnerNo set here. If they are different, the received information is
discarded. An error message to this effect is entered in the diagnostic
buffer (event ID B130).
PartnerObjectNo
Name: PartnerObjectNo
Declaration: INPUT
Data type INT
Default: 0
Explanation Object number of the partner
Range of values: 0 or 1 ... 32000
The number of the object (= DB number) on the partner with which the FB
communicates, i.e. to which the FB sends data or from the FB receives data,
must be specified.
Point to note when PartnerObjectNo = 0 in various typical classes: