Technical data

SINAUT TD7 software package for the CPU
2.1 Overview
Software
System Manual, 07/2009, C79000-G8976-C222-07
195
Copying
With the method described below, you copy the entire content of the S7 program from the
source CPU to the target CPU(s). Following this, you correct the CPU SDBs and the
SINAUT data blocks (BasicData, XComData, PComData, BComData) on the target CPUs.
You do this by saving in the 'Subscriber Administration' SINAUT configuration tool.
Step 1
● Open the S7 Program(..) directory on the CPU whose program you are using as a
template.
● In the right-hand window, select all three subdirectories Sources, Symbols and Blocks
(see figure).
● Copy the selected elements to the clipboard: Either using the 'Copy' function in the 'Edit'
menu or using the Windows key combination
Ctrl + C .
Figure 2-13 Selecting the program of the source CPU
Step 2
● Now open the S7 Program(..) directory of the CPU in which you want to insert the
program from the clipboard.
● In the right-hand window, select the three subdirectories Sources, Symbols and Blocks
again.
● Then start the 'Paste' function: Either using the 'Paste' function in the 'Edit' menu or using
the Windows key combination
Ctrl + V .
Repeat step 2 for all other CPUs that require the same program.
Step 3
● Go to the 'Subscriber Administration" SINAUT configuration tool and save.
● In the 'Properties' dialog box, make sure that there is a checkmark before
– 'System data blocks for TIMS and CPUs'
and
– 'SINAUT TD7 blocks for CPUs'.
● Then click on 'OK'.