Technical data

Configuration software for SINAUT ST7
1.11 Saving and generating system data
Software
System Manual, 07/2009, C79000-G8976-C222-07
167
In both cases, the compilation results in an executable TD7 program in the block directory.
The selected sequence also ensures that any blocks that have been removed are always
added again.
CPU-specific blocks
For all the blocks required dependent on the configuration, users can have them copied to
the relevant CPU automatically from the SINAUT TD7 master source file.
This function is controlled by the symbol table in the relevant CPU. The user enters the
required SINAUT TD7 blocks there. If, during compilation, it is determined that
● a symbol table entry exists for a single block,
● this block, however, does not exist in the user program of the CPU,
This block will be included in the generated source file.
The user can use the symbol table as a list of requirements. This makes it unnecessary to
put together the CPU program by copying source files or blocks.
You will find an overview of the blocks generated in this way either in the SINAUT TD7
documentation, in the SINAUT TD7 master source file or in the symbol table of the SINAUT
TD7 library.
Further user activities
The user now only needs to call FC BasicTask in OB1 and FC Startup in OB100 to activate
the basic functionality of SINAUT TD7.
Note
For more detailed information on this and setting parameters for the data messages, refer to
the description of the
TD7onCPU software package.
With the generation/compilation functions, the user can also completely recompile the
SINAUT program with the block numbers stored in the symbol table by deleting all SINAUT
blocks in the user program and recompiling the source file.
1.11.4 Creating SINAUT subscriber numbers as comments
To make the subscriber numbers that are important for SINAUT communication visible in the
SIMATIC Manager or in the hardware configuration, subscriber administration allows you to
enter the subscriber number of SINAUT-networked components in the comment field of the
properties.
The function is activated by selecting the option
Subscriber number as comment for stations,
CPUs and TIMs
in the Options dialog when you call the Save function in the Options dialog.
With the following subscribers networked over SINAUT, the subscriber number is entered in
the comment bar of the SIMATIC Manager:
● Stations:
● CPU modules