Technical data

Configuration software for SINAUT ST7
1.10 TD7onTIM software package
Software
128 System Manual, 07/2009, C79000-G8976-C222-07
Name: General request supervision time
Range of
values:
10 ... 32000 s
Default: 900 s
Explanation: The
General request supervision time is the maximum time required by a
destination subscriber to respond fully to a general request (GR). If the GR
response has not arrived completely at the requesting TIM module when
the supervision time has expired, a message is entered in the diagnostic
buffer of this TIM module and an ID in the objects of the TD7onTIM
involved.
A TIM can only send requests to SINAUT stations with TD7 software; in
other words, a CPU with TD7onCPU or a CPU with a local TIM with
TD7onTIM.
The time should be set generously. Particularly with dial-up connections,
remember that the time for connection establishment is also included in the
supervision time. In addition to this, on dial-up stations with messages
stored in the send buffer, the GR can be further delayed because the
requested messages are entered after all other messages in the send
buffer.
Name: Time stamp
Range of
values:
Function active, function deactivated
Default: Function deactivated
Explanation: This parameter specifies whether or not messages with a time stamp are
sent to this destination subscriber. If this is the case, the
Timestamp option
must be activated.
TD7onTIM can send either all messages with or all messages without a
time stamp to a destination subscriber. Mixing messages to a destination
subscriber with and without time stamps is not possible.
Copying parameters to other destination subscribers
Once the destination subscriber-specific parameters have been set for a destination
subscriber, they can be transferred to other destination subscribers that require the same
parameters. Follow the steps outlined below:
1. Select a destination subscriber for which you have already set the parameters in the list
box.
2. Select
Copy in the context menu (right mouse button).
3. Select a second destination subscriber in the list box.
4. Transfer the parameters to this second destination subscriber using
Paste in the context
menu.