Technical data

Configuration software for SINAUT ST7
1.10 TD7onTIM software package
Software
System Manual, 07/2009, C79000-G8976-C222-07
117
The assignment of the provider is saved when you exit the properties dialog in the SINAUT
configuration tool ("MSC Station List" tab) with "OK".
Configuring the provider data
You cannot edit the provider data at this point in the "List of GPRS Providers" dialog. To edit
the data, close both open dialogs and reopen the "List of GPRS Providers" dialog again by
clicking on the globe icon (
) in the toolbar in the window of the SINAUT configuration tool.
1.9.12 "Library Info" tab
Library Info tab
This tab shows the name, path, version, date of creation and source information for the
German and English version of the
SINAUT TD7 library with which system data for the
current CPU will be generated.
1.9.13 Printing subscriber lists
To provide users with an overview of the existing SINAUT subscribers, the SINAUT
configuration tool provides the option of printing out the list of subscribers.
A print preview function is available to check the output before printing.
1.10 TD7onTIM software package
1.10.1 Introduction
SINAUT communication between the CPU modules or between CPU modules and a control
center is implemented with the aid of TIM modules. The organization of SINAUT
communication is handled by the
SINAUT TD7 software package. In a SINAUT station, the
TD7 software must be available either on the CPU or on a TIM. For these two situations, the
SINAUT TD7 software is available in two variants:
● TD7onCPU:
The TD7onCPU software package is used on the CPU and is mandatory in all stations
with TIM modules that do
not have TD7onTIM.
In stations
with TD7-compliant TIM modules, it can be used on the CPU modules. You
configure in the STEP 7 Editor in STL (Statement list), FBD (Function Block Diagram) or
LAD (Ladder Logic).
TD7onCPU is described in a separate section.
● TD7onTIM:
The TD7onTIM software package is available only for TIM modules that are TD7onTIM-
compliant (for example TIM 3V-IE) and is part of the TIM firmware.
If you use TD7onTIM, little or no work memory is required on the CPU. You configure in
the subscriber administration of the SINAUT ST7 configuration tool.