Technical data

Configuration software for SINAUT ST7
1.9 Subscriber administration in the SINAUT configuration tool
Software
System Manual, 07/2009, C79000-G8976-C222-07
111
Information in the "MSC Station List" tab
Figure 1-60 "Properties of Subscriber" dialog of the MSC master, "MSC Station List" tab
The "Ethernet interface 1" table shows all MSC stations of the project and specifies the
subscriber number, station address, module type, station name (from NetPro) and provider
name. The globe icon at the start of the row shows the status of the GPRS provider.
The globe icon in this dialog has a the following meaning depending on its color:
● Green (
)
All the required properties of the provider are configured.
● Black and white (
)
The configured data of the provider is not complete.
If you select subscribers that have not been fully configured, the incomplete data is
shown in the lower part of the dialog.
Configuration in the "MSC Station List" tab
Follow the steps below to configure the MSC subscribers:
1. Configure the data of the MSC master by clicking the "MSC Master Properties..." button.
2. Configure the data of the MSC stations by double-clicking on a station in the list or using
the "MSC Station Properties" shortcut menu command.