Technical data
Configuration software for SINAUT ST7
1.9 Subscriber administration in the SINAUT configuration tool
Software
System Manual, 07/2009, C79000-G8976-C222-07
105
In the tree display on the left-hand side, you can see the configured SMS messages in a tree
structure with the following information:
● The highest level of the tree displays the current CPU with the text:
STEP 7 name of the CPU / type of the CPU / CPU short name
● The second level contains the configured data blocks with the text:
Block number / DB short name
● The third level lists the messages of the relevant DB with the text:
Message number - signal address (byte.bit) - "message text"
In the tree display, the status of the object is indicated by the type of symbol used.
Table 1- 4 Symbols of SMS Configuration
Correctly configured DB, data will be generated
Incompletely configured DB, data will not be generated
Activated SMS message
Deactivated or empty SMS message
Activated SMS message with incoming/outgoing status
Deactivated or empty SMS message with incoming/outgoing status
Below the tree display there is an information area in which the following characteristic data
of the object selected in the list is displayed:
●
CPU
selected:
Subscriber number and current size of an SMS message
●
DB
selected:
Number of signals, current DB size, message numbers in this DB, main mobile number
and backup mobile number
●
Message
selected:
Signal address type and message text
To the right of the tree display of the messages, there are buttons that are triggered the
available processing functions. The available functions can also be started using the context
menu (right mouse button) when an object is selected. Functions are only possible when a
CPU, a DB, or a message was selected in the
SMS messages
list.
The range of active functions depends on the selected object. The functions available in
SMS configuration are as follows:
●
+ DB
(Add DB) :
A new data block is added. A free number is searched for as the DB number, starting at
the maximum number for the current CPU.
●
+ Message
(Add Msg) :
A new enter message is added to the current DB. New messages are deactivated as
default and must be activated before they can be sent.