Technical data
Configuration software for SINAUT ST7
1.9 Subscriber administration in the SINAUT configuration tool
Software
104 System Manual, 07/2009, C79000-G8976-C222-07
●
SINAUT data blocks to generate
:
–
DB no.
and
name (header)
of the DB BasicData:
This number is either read from the symbol table or is assigned the default 127. The
number can only be modified if the complete SINAUT program with the supplied
sources is recompiled.
–
DB no.
and
name (header)
of the communication data blocks and in the column
to TIM
the subscriber number of the partner TIM.
Based on the existing blocks and the maximum value, the program proposes the
numbers for all required data blocks. The user can change these numbers when
necessary.
1.9.10 "SMS Configuration" tab
SMS Configuration
tab
In the
SMS Configuration
tab, you configure all the SMS messages required for the current
CPU. This is only possible if the corresponding DB SMS_Control was created on the CPU.
Several SMS data blocks can be defined per CPU and these can in turn contain several
SMS messages.
Figure 1-56
Properties of subscriber
dialog (CPU),
SMS Configuration
tab