User Manual

MCR METER Manual
8
 NO SAVE : Each boot display parameters for the default
configuration of the instrument.
PassWord ：OFF,LOCK SYSTEM,LOCK FILE,MODIFY,SAVE TO U_DISK
 OFF : No password
 LOCK SYSTEM : File and boot need password to perform the operation
 LOCK FILE : File requires a password to perform the operation
 MODIFY : Modify password.
Factory default password : 0010(MCR5010)
0100(MCR5100)
0200(MCR5200)
 SAVE TO U_DISK : Save the password to U disk.For example, the password file named
"0010.STA" (determined by the instrument model).When the instrument operation need to
enter a password, can advance with password U disk plug the USB interface of the
instrument, instrument will automatically detect the password file is valid, so as to achieve
the purpose of lifting passwords.
3.6 <COMM SETUP>
This page can be set as follows:
Bus Mode ：RS232C,GPIB,USBTMC,USBCDC
BaudRate ：INCR+,DECR-（4800,9600,19200,38400,115200）
Data Bit ：6,7,8
Stop Bit ：1,2
Parity ：None,Odd,Even
Tx Term ：LF 0x0A,CR 0x0D,LFCR
GpibAddr ：In the 0~31 value through the softkey or the number keys set.
3.7 <ABOUT>
Press [ABOUT SYSTEM] softkey into <ABOUT> page.
This page display instrument ID number and other registered information.
Soft key functions are as follows:
 Reset：press it to restart this instrument.
 Factory：Instrument returned to the factory status. Need to enter a password to confirm.
 Update：Push button upgrade system. Need to insert the U disk with the upgrade file
 EXIT：Return to < SYSTEM SETUP> page.
3.8 <INTER Files List> , <EXT Files List>