User Manual

MCR METER Manual
16
Figure 5-3 Schematic diagram of Handler interface signal
 When the internal power supply is used, the 1 and 2 of the J205 are connected; the 1
and the 2 of the J204 are connected.
 When using an external power supply (factory default), the 2 and 3 of the J205 are
connected; the 2 and 3 of the J204 are connected.
Chapter 6 Operation example
6.1 Clear operation
One way to clear：（In this way, the instrument will clear all the frequency points）
Figure 6-1 Measurement display page
Step:
1. As shown above ,when the cursor is in <MEAS DISP> , the [Quick Clear] soft key will be
displayed .
2. Press [Quick Clear] soft key, “To make UNKNOWN short”will be displayed on the screen. At
this time, there are 3 regional soft options: [YES] ,[NO], [CANCEL].
3. Select [CANCEL], then quit the operation of SHORT;
Select "NO", skip the SHORT operation, and enter the fourth step；