User Manual

MCR METER Manual

The parameters set by the user in form of a file stored in the instrument internal non-volatile

memory, when the next time you want to use the same settings, users do not need to set these

parameters, only need to load the appropriate file, the last set of parameters are obtained. Thus

greatly saving the time for the user to re set the parameters and improving the production

efficiency.

Press FILE button to enter the < INTER Files List > page. Press the FILE key again to switch

the internal / external file.

Operation procedure description:

A. Review existing files

1) By using the upper and lower keys, one by one look.

2) Use the left and right buttons, can look at the page.

3) Input file number keys corresponding to the serial number, then press the button [OK],

can be directly read the required file.

B. Follow these steps to save the parameter to the file.

1) The number at the cursor to need to save the file, press [STORE] softkey;

2) Select softkey [YES] into the next step, select the key [NO] cancel the save operation;

3) If step 2) select [YES], use the numeric keys to enter the file name and press [OK] to

confirm. If the serial number is already in the file, you can override the file or cancel the

operation according to the screen.

C. Follow these steps to load the parameters set in the corresponding file.

1) Press the FILE key to switch to the file management page.

2) Move the cursor to the file location in the file list, or direct input file serial number.

3) Press LOAD key.

4) Select softkey YES, loading the current file, and return to the current page.

D. Follow the steps for copying files to E (U disk).

1) Insert the U disk into the instrument front panel USB interface.

2) Move the cursor to the file, press the soft key "copy to E:"

3) According to the screen, press the soft key "YES" to copy.

4) If U disk file with the same file name, screen prompt the need to cover, according to the

soft key "YES" to continue copying, press the soft key "NO", cancel the copy.

Chapter 4 Performance

Specific reference to each model parameter table in the appendix.

The following is part of the parameter description: