Specifications

GT SERIES USER MANUAL
9
REV.1.22
MATRIX AMPLIFICATION
(7) Input Signal Sockets
.
These are combined female XLR and 1/4" jack sockets.
They provide a number of connection possibilities, including the industry standard Balanced
XLR system, which helps ensure interference and noise free connections between equipment.
Ready-made, sensibly priced, quality interconnection leads suitable for use with the amplifier
should be easy to source. However, with sufficient skill, it is possible to make/modify leads for
the task. Proceed to Chapter 5. - “Cables, Making your own”.
(8) Power Connection.
.
Mains power is supplied to the amplifier by a standard 10 Amp IEC mains socket.
An appropriate mains lead is supplied with the amplifier.
Note: The amplifier requires a stable power supply to function as intended. Ensure that the
power source (mains power supply, generator, etc.) is suitable for this application and adequate
power is available. Poorly selected power sources result in sub-optimal performance, increased
likelihood of tripping breakers, blowing fuses and in extreme situations damage to equipment
may occur.
Should the fuse in the mains lead blow for any reason, it must be replaced with a fuse of
the correct rating. This should be 13 amps for the models listed in this manual. However, if
there is any reason to believe that a malfunction caused the fuse to blow, stop using the
equipment immediately and take the amplifier to an authorised service engineer for servicing.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
— Reorient or relocate the receiving antenna.