Specifications
GT SERIES USER MANUAL
3
REV.1.22
MATRIX AMPLIFICATION
1. Features and Innovations
All our amplifiers have been designed to give the best possible performance for their
intended application and are based on our own uncompromising, time proven MOSFET designs.
These take advantage of components which will stand the test of time and give the best possible
performance in a small, exceptionally light weight package.
We only have the desire to provide our users with the best possible solutions and continue to
look for ways to improve upon them.
Amplifier features:
Design Optimised for Guitar Amplification.
Class AB, MOSFET amplifier topology.
Three independent Mono amplifier channels in one unit of rack space.
Designed primarily as a one box solution for wet/dry/wet setups, however there are many other
situations where this configuration is likely to prove invaluable.
..
An unprecedentedly powerful and stable Switch Mode Power Supply.
Designed without compromise, to exceed the performance of the previous linear supply models;
whilst offering a weight advantage rarely seen even in other SMPS amplifiers.
.
Soft Start Circuit.
The power supply is designed not to draw excessive current on startup - Prevents the 'thump' as
occasionally occurs with other equipment, from tripping fuses and breakers.
.
Protection against Short Circuit and Overheating.
.
Speaker Protection relay with delay to inhibit switch on thump.
The speakers are disconnected during power up/down.
Fully balanced XLR Inputs, which also accept 1/4” jack connectors..
.
Speakon / 1/4” Jack Combi Outputs.
Expanded output options for guitar amplifier use.
.
Temperature regulated, High Speed Fan Cooling.
A high speed fan is utilised to ensure maximum reliability by allowing for far greater cooling
latitude (The amplifier vents hot air through rear connector panel).
.
0.775v / 0 dBu Inputs.
Input level optimised for guitar amplifier use.
.
1U Case Format.
Compact amplifier format designed to optimise the use of available racking space.