Specifications

GT SERIES USER MANUAL
13
REV.1.22
MATRIX AMPLIFICATION
5.2 Speaker Leads.
Speakon Connector (4 pin) and 1/4” Jack:
Cable Maker Table:
Cable Connections:
Cable Type:
+ and -
+ and -
Single Channel, 2 core lead.
Outputs A, B and C - 4 ohms min. load
1 to 1
-
Bridged (mono) mode.
Not Applicable.
Choosing a suitable Cable:
For most applications we recommend a twin core cable with a copper core of at least 2.5mm
2
/ 12 awg & sold for the purpose of connecting power amplifiers to loudspeakers.
For cables longer than 6m/20ft a heavier gauge cable may provide improved performance.
An approximate guide of cable sizing in relation to that of a pencil is shown below, also note
on the right the thin 'bell wire' / budget domestic speaker cable... never use cable of this gauge
to connect to power amplifiers, this can present a fire risk and will result in poor performance.