Owner`s manual

2726
LOCATION OF THE UNIT
Place the unit on a level and stable surface away from direct sunlight.
The intense UV light can cause discoloration on the plastics. Locate
your unit in an area with cool temperatures and low humidity. Please
leave a clear zone behind the unit that is at least 24” (600 mm). This
zone must be clear of any obstruction and provide the user a clear
exit path from the machine. Do not place the unit in any area that will
block any vent or air openings. The unit should not be located in a
garage, covered patio, near water or outdoors.
LEVELING THE UNIT
Your unit should be level for optimum use. Once you have placed
your unit where you intend to use it, raise or lower one or both of the
adjustable levelers located on the bottom of the frame. Use 6mm
hex key through the access hole (shown right)*. A carpenter’s level is
recommended.
*NOTE: There are only two levelers on these units.
24” 600 mm
Our equipment is heavy,
use care and additional
help if necessary when
moving. Failure to follow
these instructions could
result in injury.
WARNING
BEFORE USING THE UNIT PERFORM INITIAL SETUP.
TROUBLESHOOTING
& MAINTENANCE
MX14_AEALB3x_5x_7xe_7xi_OM_Rev1_1.indd 26-27 6/4/14 11:24 AM