Specifications

69
9.21 TESTING THE ELLIPTICAL TRAINER
ONCE THE UNIT OR REPLACEMENT PART IS FULLY INSTALLED AND ASSEMBLED AND
PROPERLY PLACED ON THE FLOOR, USE THE FOLLOWING INSTRUCTIONS TO SETUP
AND TEST THE MACHINE:
1) Check that the console is set for elliptical.
a. Press ENTER, 3, 0, 0, 1, ENTER on the upper keypad to enter Service Mode.
b. Press the key next to SETUP on the display.
c. Press the key next to MACHINE TYPE on the display.
d. Press the key next to ELLIPTICAL on the display.
e. Press the key next to NORMAL EP on the display.
f. Press the BACK and HOME keys or press and hold the STOP key for 3-5 seconds to return to normal function.
2) Enter the serial number of the frame into the console. To do so:
a. Press ENTER, 3, 0, 0, 1, ENTER on the upper keypad, Service Mode will appear on the display.
b. Press the key next to SETUP on the display.
c. Press the key next to SERIAL NUMBER on the display.
d. Press the key next to PLATFORM on the display.
e. Enter the last 8 digits of the serial # from the base frame of the unit (see Section 1.1 for serial number location).
f. Press the key next to OK on the display to save the serial number.
g. Press the BACK and HOME keys or press and hold the STOP key for 3-5 seconds to return to normal function.
3) Without hitting start or entering any exercise modes, stand on the machine and hold the handlebars while initiating movement to simulate
exercising. While moving listen for any odd noises or squeaks.
4) After stopping movement, press the green GO key and begin using the machine.
5) Grasp the hand grips to check for proper heart rate response.
6) Press the LEVEL UP and DOWN keys both on the hand grips and on the console to make sure resistance is fully functional.
7) If everything functions properly, stop pedaling and the unit will reset to normal operation after 30 seconds.
CHAPTER 9: PART REPLACEMENT GUIDE